Powertrain
Definition only
Lights the check engine lamp
P2634: Fuel Pump B Control Circuit High
Standardized SAE J2012 code · P26xx — Computer and output circuits
What does P2634 mean?
Voltage on the second fuel pump control line is above the expected window. Typical causes are a short to battery or an open motor winding.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Check engine light on
- Hard start, no start, or stalling under load
- Power loss especially at high load or rpm
- Possible long cranking time
Common causes
- High Control wire shorted to B+
- Medium Open motor winding
- Low Connector pins corroded - high contact resistance
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of P2634 on the same make and model first.
P2634 in the community
Ask about P2634No one has posted about P2634 yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your P2634 problem