P248E: EGR Cooler Bypass Control Circuit Open Bank 2
Standardized SAE J2012 code · P24xx — Auxiliary emission controls
What does P248E mean?
The EGR cooler bypass valve on bank 2 - routes EGR around the cooler during cold-start to keep cabin and engine warm-up fast - has an open control circuit.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Check engine light on
- Pinging or knocking under load
- Power loss and hesitation
- Possible rough idle
- Failed emissions inspection (NOx)
Common causes
- High Open in valve or wiring
- Low Pin pushed back out of connector body
- Low Cracked solder joint inside the module or sensor
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of P248E on the same make and model first.
P248E in the community
Ask about P248ENo one has posted about P248E yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your P248E problem