Powertrain
Definition only
Lights the check engine lamp
P2095: B Camshaft Position Actuator Control Circuit High (Bank 2)
Standardized SAE J2012 code · P20xx — Fuel & air metering and auxiliary emission controls
What does P2095 mean?
The exhaust (B) camshaft phaser solenoid drive line on bank 2 is stuck high — short to B+ or open ground.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Common causes
- High Short to B+
- Low Connector pins corroded - high contact resistance
- Low Supply wire pinched against B+ source
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of P2095 on the same make and model first.
P2095 in the community
Ask about P2095No one has posted about P2095 yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your P2095 problem