Network & communication
Definition only
Lights the check engine lamp
U3560: Cathode Backpressure Valve Position Sensor Circuit
Standardized SAE J2012 code · U35xx codes
What does U3560 mean?
Generic fault on the position sensor of the cathode back-pressure valve (closed-loop position feedback).
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Common causes
- High Position sensor failed
- Low Gateway module routing CAN messages incorrectly
- Low CAN terminating resistor (120 Ω) drifted out of spec
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of U3560 on the same make and model first.
U3560 in the community
Ask about U3560No one has posted about U3560 yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your U3560 problem