U030B: Software Incompatibility With Glow Plug Control Module 2
Standardized SAE J2012 code · U03xx — Software incompatibility
What does U030B mean?
A module reports a software version mismatch with glow plug control module 2 — typically after replacing one of the modules without programming the new unit to match the rest of the network.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Common causes
- High Module replaced without programming
- Medium Wrong part number for the vehicle
- Low Gateway module routing CAN messages incorrectly
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of U030B on the same make and model first.
U030B in the community
Ask about U030BNo one has posted about U030B yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your U030B problem