U013E: Lost Communication With Vacuum Sensor B
Standardized SAE J2012 code · U01xx — Lost communication with modules
What does U013E mean?
ECU lost CAN communication with vacuum sensor B (often a smart sensor with bus interface). A communication loss with this module breaks any function relying on its data — diagnostic tools may show 'no response' and dependent modules can fall into limp mode.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Common causes
- High Sensor unpowered
- Low Gateway module routing CAN messages incorrectly
- Low CAN terminating resistor (120 Ω) drifted out of spec
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of U013E on the same make and model first.
U013E in the community
Ask about U013ENo one has posted about U013E yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your U013E problem