P267E: B Rocker Arm Actuator Position Sensor Circuit Intermittent/Erratic Bank 2
Standardized SAE J2012 code · P26xx — Computer and output circuits
What does P267E mean?
The position sensor signal for actuator B on bank 2 jumps or drops out intermittently. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Common causes
- High Sensor connector not fully seated
- Medium Harness chafed against valve cover
- Low Connector with intermittent contact under vibration
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of P267E on the same make and model first.
P267E in the community
Ask about P267ENo one has posted about P267E yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your P267E problem