Powertrain
Definition only
Lights the check engine lamp
P2628: O2 Sensor Pumping Current Trim Circuit High Bank 1 Sensor 1
Standardized SAE J2012 code · P26xx — Computer and output circuits
What does P2628 mean?
The wide-band trim resistor circuit on bank 1 sensor 1 reads high. Air-fuel feedback gain is wrong, causing offsets that the controller cannot compensate.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Check engine light on
- Increased fuel consumption
- Possible rough idle or hesitation
- Failed emissions test
Common causes
- High Open calibration trim resistor
- Medium Corroded sensor connector
- Low Supply wire pinched against B+ source
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of P2628 on the same make and model first.
P2628 in the community
Ask about P2628No one has posted about P2628 yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your P2628 problem