P2088: Camshaft Position A Actuator Control Circuit Low (Bank 1)
Standardized SAE J2012 code · P20xx — Fuel & air metering and auxiliary emission controls
What does P2088 mean?
Drive voltage to the intake VVT oil control valve on bank 1 reads below the lower limit. Usually a short to ground or a coil shorted internally.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Common causes
- High Drive line shorted to ground
- Medium Solenoid coil internally shorted
- Low Connector pins corroded - high contact resistance
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of P2088 on the same make and model first.
P2088 in the community
Ask about P2088No one has posted about P2088 yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your P2088 problem