P207E: Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit Intermittent (Bank 2)
Standardized SAE J2012 code · P20xx — Fuel & air metering and auxiliary emission controls
What does P207E mean?
IMT position sensor at bank 2 signal is unstable — connector or harness issue. The intake manifold runner control (IMRC) flaps tune intake geometry for filling efficiency across the rpm range; stuck flaps cost part-load torque and can set lean codes.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Common causes
- High Intermittent connector
- Low Connector with intermittent contact under vibration
- Low Harness routed against vibrating component
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of P207E on the same make and model first.
P207E in the community
Ask about P207ENo one has posted about P207E yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your P207E problem