P206D: Reductant Quality Sensor Circuit High
Standardized SAE J2012 code · P20xx — Fuel & air metering and auxiliary emission controls
What does P206D mean?
DEF quality sensor reads above upper plausibility — open signal or short to B+. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- Check engine light or NOx warning on
- AdBlue/DEF level or quality warning
- Possible no-start countdown after ignore period
- Failed emissions inspection (NOx)
Common causes
- High Open signal line
- Low Connector pins corroded - high contact resistance
- Low Supply wire pinched against B+ source
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of P206D on the same make and model first.
P206D in the community
Ask about P206DNo one has posted about P206D yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your P206D problem