C0575: Brake Pressure Sensor D Circuit Low
Standardized SAE J2012 code · C05xx codes
Safety-critical system. Faults in airbags, brakes, steering or high-voltage components can put people at risk. Follow the manufacturer's service information and safety procedures, or have the vehicle checked by a qualified workshop.
What does C0575 mean?
The EPB module has detected an out-of-range position signal from a caliper actuator. The module cannot determine whether the brake is fully applied or released.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- ABS warning light on
- ESC/stability control deactivated
- Possible reduced brake assist
- Speedometer may behave erratically
Common causes
- High Actuator position sensor failed
- Medium Actuator mechanically jammed (corrosion)
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of C0575 on the same make and model first.
C0575 in the community
Ask about C0575No one has posted about C0575 yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your C0575 problem