C0560: Calibration Required
Standardized SAE J2012 code · C05xx codes
Safety-critical system. Faults in airbags, brakes, steering or high-voltage components can put people at risk. Follow the manufacturer's service information and safety procedures, or have the vehicle checked by a qualified workshop.
What does C0560 mean?
The chassis control module reports that a sensor or system calibration must be performed — for example after replacement of the steering angle, yaw rate or radar sensor. Affected functions remain disabled until calibration is completed.
The code tells you which monitor failed, not which part is broken. Test before replacing parts.
Symptoms
- ABS warning light on
- ESC/stability control deactivated
- Possible reduced brake assist
- Speedometer may behave erratically
Common causes
- High Required calibration not performed after service
- Medium Calibration drive cycle incomplete
Likelihood is a general estimate across vehicles; your make and model may differ.
Add your car to see reports of C0560 on the same make and model first.
C0560 in the community
Ask about C0560No one has posted about C0560 yet
Share your vehicle, the tool you used and what you tested — the first thread helps everyone who searches for this code.
Describe your C0560 problem